Search results
Results From The WOW.Com Content Network
Pulsed radiofrequency is the technique whereby radio frequency (RF) oscillations are gated at a rate of pulses (cycles) per second (one cycle per second is known as a hertz (Hz)). Radio frequency energies occupy 1.0 × 104 Hz to 3.0 × 1011 Hz of the electromagnetic spectrum. Radio frequency electromagnetic energy is routinely produced by RF ...
The radio spectrum is the part of the electromagnetic spectrum with frequencies from 3 Hz to 3,000 GHz (3 THz ). Electromagnetic waves in this frequency range, called radio waves, are widely used in modern technology, particularly in telecommunication. To prevent interference between different users, the generation and transmission of radio ...
This gives a net polarization that is parallel to the external field. Application of an RF pulse can tip this net polarization vector sideways (with, i.e., a so-called 90° pulse), or even reverse it (with a so-called 180° pulse). The protons will come into phase with the RF pulse and therefore each other. [citation needed]
Radio frequency ( RF) is the oscillation rate of an alternating electric current or voltage or of a magnetic, electric or electromagnetic field or mechanical system in the frequency [ 1] range from around 20 kHz to around 300 GHz. This is roughly between the upper limit of audio frequencies and the lower limit of infrared frequencies, and also ...
A chirp is a signal in which the frequency increases ( up-chirp) or decreases ( down-chirp) with time. In some sources, the term chirp is used interchangeably with sweep signal. [ 1] It is commonly applied to sonar, radar, and laser systems, and to other applications, such as in spread-spectrum communications (see chirp spread spectrum ).
The pulse-repetition frequency (PRF) is the number of pulses of a repeating signal in a specific time unit. The term is used within a number of technical disciplines, notably radar . In radar, a radio signal of a particular carrier frequency is turned on and off; the term "frequency" refers to the carrier, while the PRF refers to the number of ...
The RF signal may be processed to deduce position information by looking at the changes in RF level and phase caused by varying the local magnetic field using gradient coils. As these coils are rapidly switched during the excitation and response to perform a moving line scan, they create the characteristic repetitive noise of an MRI scan as the ...
Dwell time ( TD) in surveillance radar is the time that an antenna beam spends on a target. [ 1] The dwell time of a 2D–search radar depends predominantly on. the turn speed n of the antenna (in rotations per minute or rpm, i.e. 360 degrees in 60 seconds = multiplied by a factor of 6). Dwell time is calculated by: A block of constant PRF and ...