Ad
related to: idle sensor symptoms
Search results
Results From The WOW.Com Content Network
The IAC actuator is an electrically controlled device, which gets its input from the vehicle's engine control unit (ECU). The actuator is fitted such that it either bypasses the throttle or operates the throttle butterfly valve directly. The actuator consists of a linear servo actuator servomotor that controls a plunger which varies air flow ...
Electronic throttle control ( ETC) is an automobile technology that uses electronics to replace the traditional mechanical linkages between the driver's input such as a foot pedal to the vehicle's throttle mechanism which regulates speed or acceleration. This concept is often called drive by wire, [ 1][ 2] and sometimes called accelerate-by ...
A crankcase ventilation system ( CVS) removes unwanted gases from the crankcase of an internal combustion engine. The system usually consists of a tube, a one-way valve and a vacuum source (such as the inlet manifold ). The unwanted gases, called "blow-by", are gases from the combustion chamber which have leaked past the piston rings.
Ignition timing. Pressure in cylinder pattern in dependence on ignition timing: (a) - misfire, (b) too soon, (c) optimal, (d) too late. In a spark ignition internal combustion engine, ignition timing is the timing, relative to the current piston position and crankshaft angle, of the release of a spark in the combustion chamber near the end of ...
A throttle position sensor ( TPS) is a sensor used to monitor the throttle body valve position for the ECU of an engine. The sensor is usually located on the butterfly spindle/shaft, so that it can directly monitor the position of the throttle. More advanced forms of the sensor are also used. For example, an extra "closed throttle position ...
Mass flow sensor. A mass (air) flow sensor ( MAF) is a sensor used to determine the mass flow rate of air entering a fuel-injected internal combustion engine . The air mass information is necessary for the engine control unit (ECU) to balance and deliver the correct fuel mass to the engine. Air changes its density with temperature and pressure.
During engine idle, brief but periodic negative pressure pulses in the exhaust system draw air through the aspirator valve and into the exhaust stream at the catalytic converter. This system, marketed as Pulse Air, was used by American Motors, Chrysler, and other manufacturers beginning in the 1970s. The aspirator provided advantages in cost ...
A Hall effect sensor (also known as a Hall sensor or Hall probe) is any sensor incorporating one or more Hall elements, each of which produces a voltage proportional to one axial component of the magnetic field vector B using the Hall effect (named for physicist Edwin Hall ). Hall sensors are used for proximity sensing, positioning, speed ...
Ad
related to: idle sensor symptoms