Search results
Results From The WOW.Com Content Network
The troubleshooting method you will use consists of the following steps: a. Verify the network documentation and use tests to isolate problems. b. Determine an appropriate solution for a given problem. c. Implement the solution. d. Test to verify the problem is resolved.
In Part 1, use the Admin-PC to remotely access the Edge1 gateway router. Next, from the Edge1 router you will SSH into the Remote Branch Office. a. On the Admin-PC, open a command prompt. b. SSH into the gateway router at 192.168.1.1 using the username admin01 and the password S3cre7P@55.
10.2.3.5 Packet Tracer – Configuring Syslog and NTP (Instructor Version – Optional Lab) Topology. Objectives. Scenario. Part 1: Configure Syslog Service. Part 2: Generate Logged Events. Part 3: Manually Set Switch Clocks. Part 4: Configure NTP Service. Part 5: Verify Timestamped Logs.
Step 2: Test end-to-end connectivity across the network. You should now be able to ping from any PC to any other PC on the network. In addition, you should be able to ping the active interfaces on the routers. For example, the following should tests should be successful: From the command line on PC1, ping PC4.
CCNA 2 v7 Lab 3.5.5 Packet Tracer – Configure DTP Instructions Answer .pdf .pka file download completed 100% scored 2019 2020
Save your configurations. Verify connectivity between all devices. All devices should be able to ping all other devices with IPv4 and IPv6. Troubleshoot and document any issues. Implement the solutions necessary to enable and verify full end-to-end connectivity. Note: Click Check Results button to see your progress.
10.3.4 Packet Tracer – Connect a Router to a LAN. 10.3.5. Packet Tracer – Troubleshoot Default Gateway Issues. For a device to communicate across multiple networks, it must be configured with an IP address, subnet mask, and a default gateway. The default gateway is used when the host wants to send a packet to a device on another network.
In this activity, you are given the network address of 192.168.100.0/24 to subnet and provide the IP addressing for the Packet Tracer network. Each LAN in the network requires at least 25 addresses for end devices, the switch and the router. The connection between R1 to R2 will require an IP address for each end of the link. Instructions
R1(config-if)#ip address 209.165.200.225 255.255.255.252. d. Display the routing table by filtering to start the output at the word Gateway. Note: Terms that are used to filter output can be shortened to match text as long as the match is unique. For example, Gateway, Gate, and Ga will have the same effect.
The troubleshooting method you will use consists of the following steps: 1) Verify the network documentation and use tests to isolate problems. 2) Determine an appropriate solution for a given problem. 3) Implement the solution. 4) Test to verify the problem is resolved. 5) Document the solution. Throughout your CCNA studies, you will encounter ...