Search results
Results From The WOW.Com Content Network
hi all, i have a question regarding the output of the "show ip route" command: C 192.168.30.0/24 is directly connected, Ethernet0 172.16.0.0/24 is subnetted, 1 subnets S 172.16.1.0 is directly connected, Ethernet0 192.16...
The local routes defines a route for the one specific IP address configured on the router interface. Each local route has a /32 prefix length, defining a host route, which defines a route just for that one IP address. For example, the last local route, for 172.16.5.1/32, defines a route that matches only the IP address of 172.16.5.1.
This doesn't seem to show the actual interface, at least if the default route is used. For me, asking ip route show to match 10.32.52.167 earns the response default via 10.93.20.1 dev enp4s0f2 proto dhcp metric 100. 10.93.20.1 is my gateway, but my interface, which is 10.93.20.68, is not shown. –
And a call to ip route show table 104 shows: default via 192.168.3.7 dev eth0 If I then call ip rule del table 104, a subsequent call to ip rule list shows: 0: from all lookup local 32766: from all lookup main 32767: from all lookup default However, a call to ip route show table 104 still shows: default via 192.168.3.7 dev eth0
Let me try to put in a different way of interpreting "show ip route profile" output. The output shows the number of events/interval with respect to the attributes defined in the top row. Every interval if there is no change in the routing table, then 0 events/interval counter will keep on incrementing.
R3#show ip route 192.168.3.0 Routing entry for 192.168.3.0/24 Known via "static", distance 1, metric 0 Routing Descriptor Blocks: 192.168.12.3 Route metric is 0, traffic share count is 1 * 192.168.12.2 Route metric is 0, traffic share count is 1. As per inform earlier, the * did not move before and after i ping to PC0, and PC1.
Hello , As stated by the above post ip route summary gives you the current state of the routing table, like where excatly the routes originated and how many prefix are been used by routig protocol with number of bytes used by routes. This command is mainly used to check the state of the routing table. Hope to help !!
6. route is a fairly simple tool, perfect for creating static routes. It's still present in many distributions for compatibility. ip route is much more powerful, it has much more functionality, and can create more specialized rules. ip route isn't needed to create a static route, but as it's a much more useful tool, the effort expended in ...
The basic configuration of a VRF only requires two steps: 1.) Create the VRF - (config)# ip vrf <vrf name>. Note: Instance names are case sensitive. 2.) Associate the VRF to the appropriate interface (s) - (config-if)# ip vrf forwarding <vrf name>. Note: By default, all interfaces belong to the global IP routing table.
<show forwarding distribution ip multicast route vrf (vrf)> - shows IPv4 multicast routing table for given vrf <show forwarding distribution multicast vlan_db> - Verify FD to BD vlan mapping. MFDM gets (FD,port) memberships from vlan_mgr and uses this information go create BD floodlists.