Search results
Results From The WOW.Com Content Network
The Charrière is measured by the ''outer'' diameter, and is defined as 1 Fr = 1/3 mm, and thus 1 mm = 3 Fr; therefore the diameter of a round catheter in millimetres can be determined by dividing the French size by 3. [2] The French units roughly correspond to the outer circumference of the catheter (see table below).
He used trigonometry to calculate the radius of the Earth using measurements of the height of a hill and measurement of the dip in the horizon from the top of that hill. His calculated radius for the Earth of 3928.77 miles was 2% higher than the actual mean radius of 3847.80 miles. [ 19 ]
In aviation, pressure altitude is the height above a standard datum plane (SDP), which is a theoretical level where the weight of the atmosphere is 29.921 inches of mercury (1,013.2 mbar; 14.696 psi) as measured by a barometer. [ 2] It indicates altitude obtained when an altimeter is set to an agreed baseline pressure under certain ...
1:480. 0.635 mm. Model railways (T) T scale, using 3 mm gauge track to represent standard gauge railways. 1:450. 0.677 mm. Model railways (T) T scale, using 3 mm gauge track to represent 3 ft 6 in ( 1,067 mm) gauge railways. Hasegawa also produces plastic ship models in this scale.
Therefore, a pressure altitude of 32,000 ft (9,800 m) is referred to as "flight level 320". In metre altitudes the format is Flight Level xx000 metres. Flight levels are usually designated in writing as FLxxx , where xxx is a two- or three-digit number indicating the pressure altitude in units of 100 feet (30 m).
Geographic coordinate conversion has applications in cartography, surveying, navigation and geographic information systems . In geodesy, geographic coordinate conversion is defined as translation among different coordinate formats or map projections all referenced to the same geodetic datum. [ 1] A geographic coordinate transformation is a ...
The Ottoman Empire (1299–1923), the predecessor of modern Turkey was one of the 17 signatories of the Metre Convention in 1875. For 58 years both the international and the traditional units were in use, but after the proclamation of the Turkish Republic, the traditional units became obsolete.
Conversion of units is the conversion of the unit of measurement in which a quantity is expressed, typically through a multiplicative conversion factor that changes the unit without changing the quantity. This is also often loosely taken to include replacement of a quantity with a corresponding quantity that describes the same physical property ...